Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision
Previous revision
tutorials_light [2016/02/24 05:51]
admin created
tutorials_light [2016/11/25 17:58]
admin
Line 5: Line 5:
 We will use the [[https://​learn.adafruit.com/​adafruit-si1145-breakout-board-uv-ir-visible-sensor/​overview|Adafruit_SI1145]] library to interface with the sensor. Unzip the content of this {{::​adafruit_si1145.zip| zip file}} into the //​Arduino\libraries//​ or use Arduino IDE's Add ZIP Library command. We will use the [[https://​learn.adafruit.com/​adafruit-si1145-breakout-board-uv-ir-visible-sensor/​overview|Adafruit_SI1145]] library to interface with the sensor. Unzip the content of this {{::​adafruit_si1145.zip| zip file}} into the //​Arduino\libraries//​ or use Arduino IDE's Add ZIP Library command.
  
 +<​html><​script src="​https://​gist.github.com/​deathmeek/​161480ff156db8ebd9e560817162c441.js"></​script></​html>​
  
-<code C> +<note tip>Now that we know how to measure a lot of parameterslet's learn how to use the radio interface ​to [[tutorials_radio| send data]]!</note>
-#include <​Wire.h>​ +
-#include "​Adafruit_SI1145.h"​ +
- +
-int controlPin = 7; +
-Adafruit_SI1145 uv = Adafruit_SI1145();​ +
- +
-void setup() { +
-  pinMode(controlPinOUTPUT); ​ //sensor on/off control +
-  delay(100);​ +
-  digitalWrite(controlPin,​ LOW); +
-    +
-  Serial.begin(9600);​ +
-   +
-  Serial.println("​Adafruit SI1145 test"​);​ +
-   +
-  if (! uv.begin()) { +
-    Serial.println("​Didn't find Si1145"​);​ +
-    while (1); +
-  } +
- +
-  Serial.println("​OK!"​);​ +
-+
- +
-void loop() { +
-     +
-  Serial.println("​==================="​);​ +
-  Serial.print("​Vis:​ "); Serial.println(uv.readVisible());​ +
-  Serial.print("​IR:​ "); Serial.println(uv.readIR());​ +
-   +
-  // Uncomment if you have an IR LED attached ​to LED pin! +
-  //​Serial.print("​Prox:​ "); Serial.println(uv.readProx());​ +
- +
-  float UVindex = uv.readUV();​ +
-  // the index is multiplied by 100 so to get the +
-  // integer index, divide by 100! +
-  UVindex /= 100.0; ​  +
-  Serial.print("​UV:​ "​); ​ Serial.println(UVindex);​ +
- +
-  delay(1000);​ +
-+
-</code> +